Register · Login
About Theme

A Letterboxing Community

?
More Search Options...
[Everybody Group]
[Read Board]

Stamp Carving and Mounting

Start New Thread
Simple | Summaries | Expanded
 
Msg: 969228
DarkZen and Evil Cow Pie Subject: Solution for the back of Tan-Z
Author: DarkZen and Evil Cow PieProfileContactLogbookNote
Date: Dec 9, 2018 11:25 AM
P-94F-302M-787Premium
Over in this thread (https://www.atlasquest.com/boards/messages.php?startId=968961;threadId=140760) there was talk of the pebble texture on the back of Tan-Z and how it could be removed so both sides were usable for carving.

There was also the suggestion for using the pebble texture for ‘shading’ which I found interesting. This morning I was test printing the back (it’s got promise!). But so as not to get ink all over myself when using the front, I took a paper towel and some acetone to clean off the residue ink.

And I discovered that with a light scrubbing the pebble texture came off and left the surface as smooth as the “front” side! No slicing, no chopping, no sanding needed! I’m guessing for larger areas you might want to use a block or something to keep the surface level but the solution to getting the back carvable proved to be pretty simple.
Start New Thread
Simple | Summaries | Expanded
 
Board: Stamp Carving and Mounting
Group: Everybody