I was carving tonight and I had something strange happen with Firm Kut Grade B. It has happened before, but I didn't think to post about it before.

I was carving a curved area, varying between 1/2 cm and 1 cm wide of a cut. It was too far apart of a cut to make a "V" that met at the bottom (without going all of the way through) so I cut down and I was going to carve horizontally, sort of a slanted "U"; the sides of the "U" were slanted like a "V", but the bottom was going to be flat. However, about 2/3 of the way down the Firm Kut separated for me. It was a nice, level area about where I was going to make the cut myself but much smoother. It is like there was already a layer of Firm Kut that hadn't quite bonded.

It doesn't seem to separate at this level anywhere else, just where I wanted it to separate anyway.

Has this happened to anyone else?

The Force is strong in this one. You are carving with your mind.....
Perhaps you will be master kenobi before long.