Read Thread: another theoretical situation
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46110 by Trekkie Gal
Oct 29, 2006 11:54am
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46260 by shiloh
Oct 29, 2006 12:28pm
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46160 by ArtGekko
Oct 29, 2006 2:27pm
Okay, ArtGekko, you wanted to know. The steam from the boiling water definitely moistens up the ink on the stamp, but it makes the ink bead up, which in turn makes the stamp impression blotchy. Bummer!
TG
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46275 by Trekkie Gal
Oct 29, 2006 2:38pm
TG...how about something that's not direct boiling water....like steam from an iron?
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46277 by Jenni P McD
Oct 29, 2006 2:46pm
What about a cool mist humidifier, like you use when your kid is sick? This springs readily to my mind, because I'm currently sick, and I have one running here by me!
DebBee
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46277 by Jenni P McD
Oct 29, 2006 2:57pm
Unfortunately, some silly person had to go and buy a cheap iron. I mean, why pay a lot when you hardly ever use the thing. So the steam that comes out of the iron is, shall we say, somewhat unreliable.
I have no kids, and no humidifier.
TG
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46275 by Trekkie Gal
Oct 29, 2006 2:57pm
Anyone consider laying a *light* layer of oil down before starting to color? Like wipe across of cold cream or something similar?
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46285 by Ish
Oct 29, 2006 2:58pm
No....wouldn't that cause the ink to bead up even worse? And would that harm the markers?
TG
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46286 by Trekkie Gal
Oct 29, 2006 3:00pm
What I'm thinking of wouldn't bead the ink, but it might total the markers.
What about just barely stamping on a wet paper towel before stamping on your page?
What about just barely stamping on a wet paper towel before stamping on your page?
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46287 by Ish
Oct 29, 2006 3:06pm
At this point, I'm ready to try just about anything. And I'm also thinking that the people in this ring will kill me if I make this my main stamp. Maybe I should switch the two stamps - make the smaller, less complicated bonus the actual stamp, and turn in the larger complicated stamp into a "try it if you dare" type of thing.
TG
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46289 by Trekkie Gal
Oct 29, 2006 3:19pm
Okay....how about this....sounds retarded, but at this point, who knows. Try it on a piece of waste stamp material, cause you don't want to lose your stamp.
Try a moist paper towel UNDER the bottom side of the stamp in the microwave for 10 seconds...
assuming the stamp medium doesn't melt, try 15 sec. I wouldn't go any higher than that though...
See if that creates enough moisture in the air to keep the pigment wet...
Jenni P McD
Try a moist paper towel UNDER the bottom side of the stamp in the microwave for 10 seconds...
assuming the stamp medium doesn't melt, try 15 sec. I wouldn't go any higher than that though...
See if that creates enough moisture in the air to keep the pigment wet...
Jenni P McD
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46295 by Jenni P McD
Oct 29, 2006 5:46pm
This made me wonder whether you might be able to use the cat eye pigment inks or duo daubers, instead of markers -- they have glycerine in them and would stay moist a lot longer than the dye based markers. I don't know how detailed the carving is, but it might work..
Webfoot
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46314 by Webfoot
Oct 29, 2006 5:55pm
Mine is very detailed - no way to use anything thicker than a Le Plume II marker. Arrrrrrrgh! I did such a darn good job carving (if I do say so myself), and now I can't get a decent image.
TG
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46314 by Webfoot
Oct 29, 2006 5:57pm
This was my initial reaction too...find markers where the ink would resist drying out so quickly....I'm just not familiar enough with the different brands and products to know what's out there....
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46314 by Webfoot
Oct 29, 2006 6:10pm
That's a possibility, though with multiple colors that could get a little spendy. Don't suppose Stampeaz sells the duo daubers...? ;)
-AG
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46321 by ArtGekko
Oct 29, 2006 6:14pm
No, sorry -- I don't have duo daubers. I could probably get them, but I wanted to see how the inks I've already stocked work out for the store before spending a bunch more money. I think they might be a good idea, though. Lots of colors in very little space... :)
Webfoot
Webfoot
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46295 by Jenni P McD
Oct 29, 2006 10:31pm
Uhhhh, why don't you try the moist paper towel in the microwave WITHOUT the stamp? Get everything all moist and humid in there, then toss in the COLD stamp. You should get moisture condensing on the stamp. Who knows, maybe it'll work.
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46374 by Kirbert
Oct 29, 2006 11:46pm
You can get the same effect by putting the stamp in the freezer for a short time and when you take it out instant condensation.
Shiloh
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46110 by Trekkie Gal
Oct 30, 2006 6:59am
I have been gone again for a couple days and have NO idea if this solution has been put out there yet...
(I am just trying to get caught up on messages)
*feeling doubtful that I can catch up*
the obvious way to keep the colors moist is steam
(I am just trying to get caught up on messages)
*feeling doubtful that I can catch up*
the obvious way to keep the colors moist is steam
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46284 by Trekkie Gal
Oct 30, 2006 11:24am
steam...can come from running the hot water in the shower, sink etc??
just go run your dish water and hold your stamp over that faucet's steam.
:-)
just go run your dish water and hold your stamp over that faucet's steam.
:-)
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46110 by Trekkie Gal
Oct 30, 2006 12:22pm
There are spritzer/spray bottles that have a very fine mist when sprayed. Judikins makes one that is great -- look for it in craft stores.
These are made for gently misting inked stamps.
If you have one that you think might work, test it out but remember you should hold the bottle several inches away from the stamp and let the mist settle down onto it.
However, I don't know how these will work on Mastercarve or PZ Cut.
Try it out -- a few inches away!
KuKu
These are made for gently misting inked stamps.
If you have one that you think might work, test it out but remember you should hold the bottle several inches away from the stamp and let the mist settle down onto it.
However, I don't know how these will work on Mastercarve or PZ Cut.
Try it out -- a few inches away!
KuKu
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46538 by KuKu
Oct 30, 2006 3:15pm
Does it make any difference when you apply this spritzing? Does it work better if you use it sooner, rather than waiting too long until some of the ink is already dry?
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46585 by Kirbert
Oct 30, 2006 3:20pm
It's putting water onto/into the ink, so I think it will work well no matter when, as long as your ink is waterbased.
KuKu
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46586 by KuKu
Oct 30, 2006 6:09pm
I had a large PLB that took 4 colors (black, red, orange, and yellow) arrive, and I have never used markers before. I figured, being as full of hot air as I am, that it would be no problem inkin-and-a-huffin. I carefully applied the markers to all the right spots, blended as necessary, then prepared to huff away. 3 times I did this, and all I got was really faint images. The last time I tried, I huffed so long and hard I got dizzy, but still to no avail. Ugh! So, unwilling to give up, I boiled some water in a pan. I held the stamp about 8 inches over the water for just two or three seconds, and got a BEAUTIFUL image out of it!
Unfortunately, I was still dizzy from huffing, and seeing double. So now, there is a GORGEOUS image from the Princess Bride PLB stamped directly on my kitchen counter.
-wassamatta_u
Unfortunately, I was still dizzy from huffing, and seeing double. So now, there is a GORGEOUS image from the Princess Bride PLB stamped directly on my kitchen counter.
-wassamatta_u
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46635 by wassamatta u
Oct 30, 2006 6:12pm
I think that's called stenciling in the world of interior decorating. Put a little sealant on it, and it'll increase the value of your home!
Jenni P McD
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46637 by Jenni P McD
Oct 30, 2006 6:22pm
This stamp is WildHair's AMAZING entry in The Princess Bride PLB. And as Art alone, it would certainly be a welcome addition to any household. In most cases. However, in THIS case, I don't think it would be taken too well to have something stenciled where you prepare food that says "THERE WILL BE NO SURVIVORS!"
-wassamatta_u
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46646 by wassamatta u
Oct 30, 2006 6:31pm
she's real fine my 409... especially for taking water-based marker off kitchen counters.
unless it didn't really happen...having read some of your fiction, now I'm in a quandry, never knowing quite what I should believe of your posts...but I promise to always laugh....
because fact or fiction...it's always funny
night writer who had to go to the store and now has to make some loooong posts.... lol
unless it didn't really happen...having read some of your fiction, now I'm in a quandry, never knowing quite what I should believe of your posts...but I promise to always laugh....
because fact or fiction...it's always funny
night writer who had to go to the store and now has to make some loooong posts.... lol
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46646 by wassamatta u
Oct 30, 2006 6:38pm
Hey...if it's where you're making your MLT where the mutton's nice and lean, I don't see a problem with it!
Jenni P McD
Jenni P McD
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46635 by wassamatta u
Oct 30, 2006 6:40pm
Bleach will take it off. Use a 10% solution, lay paper towels on top, let sit a few, and wipe it up.
Chickadee
Chickadee
Re: another theoretical situation
Board: Stamp Carving and Mounting
Reply to: #46586 by KuKu
Nov 1, 2006 5:05am
i use prismacolor art markers. they are a bit more enxpensive and only sold singularly but for large stamps they retain the moisture (i still huff just in case). also they have a wide tip and a small tip so depending on the area you could use either one.
thats just my penny in.
kitten without mittens
thats just my penny in.
kitten without mittens