Read Thread: Laser carving
Re: Laser carving
Board: Tools of the Trade
Reply to: #761603 by System
Mar 1, 2013 8:02am
Same exact problem - my needle knife sits lonely in my kit because of this. I cannot control the cut for the life of me. Any ideas much appreciated ;)
Re: Laser carving
Board: Tools of the Trade
Reply to: #761624 by Bumble
Mar 1, 2013 9:04am
You guys might need to try a heavier gauge needle cut off a bit shorter so it doesn't stick out of the pin vise so far. That way, you should have enough control to force it to cut in whatever direction you want, even if the cutting edge isn't perfectly aligned with the cut you're trying to make.
Re: Laser carving
Board: Tools of the Trade
Reply to: #761636 by Kirbert
Mar 1, 2013 9:50am
Should you have to "force" it, though? Right now, when I force it, because the shape of the tip is essentially a half moon, the round part of the tip of the needle really wants to steer which is what gives me problems. This is even using the tippiest part of the tip - no more than half a millimetre.
Re: Laser carving
Board: Tools of the Trade
Reply to: #761649 by Bumble
Mar 1, 2013 1:47pm
This is what I think is the beauty of a needle. You twist the vise to make the needle go one way or the other. Think of this action like you were paddling, twist a double bladed paddle one way it will slide away from you and twist the opposite it will come in to you. I try to find a place to start the cut a little distance from the line being made. If I am not mistaken Kirberts tutorial demonstrates this. This helps get the needle going straight. To be clear I use both needle and miniaturized gouge for detail.
I found Kirbert's tutorial under links, carving.